Home | Applied Membranes Home | Purchase Online | Common Q & A | Technical Articles | Design Information  

Operating Do's and Don'ts for Reverse Osmosis Systems

DO
1. Change the cartridge filters regularly.
2. Monitor the system and keep a log daily.
3. Run the system, as much as possible, on a continuous basis.
4. Adjust the system recovery to recommended value.

DON’T
1. Permit chlorine in the feed water.
2. Shut down the system for extended periods.
3. Close the throttle valve completely.
4. Operate the system with insufficient feed flow.

 
Home Up Next

 Operating Do's & Don'ts System Recovery Membrane Foulant Identification System Troubleshooting Res. RO Troubleshooting Operation Parameters Record Keeping Pre-Start-up Check System Shut-Down

All Content on this site is  intended for informational purposes for experienced water treatment professionals only.  Applied Membranes, Inc. does not assume any liability for any damages caused by the misapplication or misinterpretation of any of the information contained on this website.
© Applied Membranes, Inc. 2007